PD-14-004FEFCO-0500

Slide type box (sleeve and tray)

Two-piece sliding corrugated box: a glued-corner inner tray and an outer sleeve sized from the tray plus caliper clearance. Opens and re-closes without tape, and doubles the board on all four sides.

Drawing…

CutCreaseGlue area

Flat blank: —
Rule length: —
Area: —
Panels: —

Size & options

Dimensions

Length (L)

Between 40 and 1,500

Width (W)

Between 40 and 1,500

Tray depth (H)

Between 10 and 800

Sleeve slide clearance

Between 0 and 20

Sleeve length

Between 0 and 1,500

Features

Gap between the two blanks

Between 5 and 200

Push-out hole in the sleeve

Push-out hole diameter

Between 10 and 90

Finger hole in the tray end wallTamper-evident perforation on the sleeve

Flaps & tabs

Sleeve manufacturer's joint

Between 10 and 150

Sleeve joint on

Joint taper

Between 0 and 30

Glue flap side

Which edge of the blank carries the manufacturer's joint. Right mirrors the whole blank - every panel, flap and lock - so the box folds the same way with the joint on the other side.

Tray corner tab depth

Between 0 and 800

Tray corner tab chamfer

Between 0 and 400

Corner slit relief

Between 0 and 12

Corner tab glued to

Production

Board caliper

Between 0.1 and 12

Grain / flute direction

Add bleed contourAdd safety contourDraw dimension linesAdd registration marks

Advanced settings+

Bleed

Between 0 and 20

Safety margin

Between 0 and 30

Order this box

Request a quote

Our structural designers review the final dieline before production.